Scheinwerfer ausbauen

Bin gerade mit meinem Rechtslenker-Dodge Caliber nach Deutschland umgezogen und muss jetzt neue Scheinwerfer verbauen. Kannmir jemand sagen wie man die Scheinwerfer ausbaut? Das ist ja nun nicht ganz so einfach...

Nein, das ist die Anleitung für den Austausch der Scheinwerfer. Die Klarglasgehäuse bleiben drin. Nur was da von hinten drin steckt, wird getauscht.

Da haste Dir was vorgenommen.

Step 1

Park the Dodge Caliber on a flat paved or concrete surface. Turn the steering wheel all the way to the side opposite the headlight you are replacing. In other words, if you are replacing the left headlight, turn the wheel all the way to the right. Apply the parking brake and release the hood latch.

Step 2

Place a wheel chock behind one of the rear tires.

Step 3

Open the hood. This is to allow some light to reach down into the engine compartment.

Step 4

Raise the front quarter panel of the side you need to replace the headlight on with the floor jack and place the jack stand under the front frame rail on that side.

Step 5

Remove the fender well plugs using the plastic plug puller tool. You do not have to remove the entire fender well cover, but the more plugs you remove, the more access it will give you to the headlight assembly.

Step 6

Unplug the headlight switch. Make sure you are unplugging the headlight which will be the inboard plug.

Step 7

Turn the headlight bezel a quarter turn counterclockwise and extract the bulb and bezel.

Step 8

Insert the new headlight into the bezel, being careful not to touch the glass bulb.

Step 9

Insert the bezel and headlight into the headlight assembly and turn a quarter turn clockwise to lock it into place.

Step 10

Plug the wire connector into the headlight. This would be a good time to get up and go test the light to make sure it's working.

Step 11

Replace the fender well skirt and plugs into place.

Step 12

Lower the Caliber and remove the wheel chock.

Ja danke, aber das ist dann wohl nur die Anleitung zum Austausch der Gluehbirne. Ich muss ja nun leider die kompletten Scheinwerfer ausbauen und mit Scheinwerfer fuer den Linksverkehr ersetzen.